Table of Contents
Advertisement
ASSEMBLY / PRE-OPERATION
TRACTION DRIVE
CON TROL LEVER
DRIVE
CONTROL
BRACKET
INSTALL AUGER CONTROL ROD (See Figs. 5 and 6)
The auger control rod has the short loop on the end of the
spring as shown.
1. Slide rubber sleeve up rod and hook end of spring into
control arm with loop opening up as shown.
2. With top end of rod positioned under right side of control
panel, push down on rod and insert end of rod into hole
in auger control bracket. Secure with retainer spring.
AUGER
CONTROL
ROD
RUBBER
SLEEVE
CONTROL
ARM
RETAINER
SPRING
TRACTION
DRIVE
CON TROL
ROD
FIG. 4
LOOP
OPENING
UP
FIG. 5
AUGER
CONTROL
ROD
INSTALL DISCHARGE CHUTE / CHUTE ROTATER HEAD
(See Fig. 7)
NOTE: The multi-wrench provided in your parts bag may
be used to install the chute rotater head.
1. Place discharge chute assembly on top of chute base
with discharge opening toward front of snow thrower.
2. Position chute rotater head over chute bracket. If nec es -
sary, rotate chute assembly to align square and pin on un-
der side of chute rotater head with holes in chute brack et.
3. With chute rotater head and chute bracket aligned,
po si tion chute rotater head on pin and threaded stud
of mounting bracket.
4. Install 3/8 washer and locknut on threaded stud and
tighten securely.
CHUTE
ROTATER
HEAD
CHUTE
BRACKET
6
AUGER
CONTROL
RETAINER
LEVER
SPRING
AUGER
CONTROL
BRACKET
FIG. 6
3/8 LOCKNUT
3/8 WASHER
THREADED
ROTATER HEAD
MOUNT ING
BRACKET
FIG. 7
PIN
STUD
Hide quick links:
Advertisement
Table of Contents
