Toshiba 2000 User Manual page 106

User's Manual
NOTES: 1. PC card HDD boot is supported only by the PC card slot
on the computer. Support is guaranteed only for TOSHIBA
PC card HDDs.
2. When you assign a PC card HDD top priority, "PC" is not
displayed. However, the PC card HDD takes the position of
HDD in the Boot Priority Options list above.
Power on Boot Select
When this option is enabled, you can change the boot drive during start up. To
change the boot drive, follow the steps below.
1. Hold down F12 and boot the computer.
2. The following menu will be displayed with the following icons: Built-in HDD,
CD-ROM, FDD, Network (LAN), PCA (ATA) card boot.
NOTE: A bar will appear only under the selected device.
3. Use the left/right cursor keys to highlight the boot device you want and press
Enter.
NOTES: 1. If a supervisor password is set, the menu above does not
appear when you use the user password to start the
computer.
2. The selection method above does not change the boot
priority settings in HW Setup.
3. If you press a key other than one of those above or if the
selected device is not installed, the system will boot according
to the current setting in HW Setup.
USB
USB KB/Mouse Legacy Emulation
Use this option to enable or disable USB KB/Mouse Legacy Emulation. If your
operating system does not support USB, you can still use a USB mouse and
keyboard by setting the USB KB/Mouse Legacy Emulation item to
Enabled.
7-8