How To Lubricate The Idler Arm - Husqvarna 521SSE Operator's Manual

HOW TO LUBRICATE THE IDLER ARM

CAUTION: DO NOT get oil on the belt or pulleys. This will
cause the belt to slip and experience premature failure.
1. Remove the screws from the belt cover (see Figure 12).
Remove the belt cover.
2. Apply a drop of oil to the idler arm at point B (see
Figure 13).
3. Pivot the auger bail up and down several times.
4. Wipe off the excess oil.
5. Install the cover.
Belt Cover
1740274
SERVICE RECOMMENDATIONS
Figure 12
19
Idler Arm
B
Figure 13