GAS O LINE
NOTE: ITEMS ABOVE
ARE SHOWN IN
LOCATION ON THE
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button – used for starting the engine.
Recoil (auxiliary) starter handle – used for start ing the
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
disengages transmission for pushing
the snowthrower with the engine off.
Throttle/engine control - used to se lect either FAST or
SLOW engine speed and to STOP the engine.
Choke control - used for starting a cold engine.
DE FLEC TOR
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power-pro-
pelled for ward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
LH and RH turn triggers - used to steer the snow thrower.
Deflector remote control lever - used to change the
dis tance the snow is thrown.
Discharge chute control lever - used to change the di rec-
tion the snow is thrown.
Drift cutter - used to cut through deep snowdrifts.
Skid plate - used to adjust height of scraper bar from the
DISCHARGE CHUTE CONTROL LEVER
CON TROL LEVER
DE FLEC TOR