Husqvarna 16530-LS Operator's Manual page 9

Husqvarna snow blower user manual
Hide thumbs

Advertisement

GAS O LINE
FILLER CAP
MUF FLER
CHOKE
CON-
TROL
PRIM ER
SAFETY
IGNITION
KEY
FUEL
SHUT-OFF
VALVE
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AU GERS
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and
wrench.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for start ing en gine.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Choke Control - used for starting a cold engine.
Throttle/engine control - used to se lect either FAST or
SLOW engine speed and to STOP the engine.
LH and RH turn triggers - used to steer the snow thrower.
OPERATION
DISCHARGE
CHUTE
THROTTLE
/ ENGINE
CONTROL
CLEAN-OUT TOOL
ELECTRIC
AUGER
START
CONTROL
BUTTON
LEVER
RECOIL
(AUXILIARY)
STARTER
HANDLE
CHUTE
DE FLEC TOR
Fig. 10
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power-pro-
pelled for ward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
snow).
Discharge chute control lever - used to change the di-
rec tion the snow is thrown.
Deflector remote control lever - used to change the di-
s tance the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground.
Drift cutter - used to cut through deep snowdrifts.
9
DISCHARGE CHUTE CONTROL LEVER
DEFLECTOR
DRIVE SPEED
REMOTE
CON TROL LEVER
CONTROL
LEVER
TRACTION
DRIVE
CONTROL
LEVER
LH TURN
TRIGGER
LIGHT
HANDLE
KNOB
MUF FLER
TOOLBOX
DRIFT
CUTTER
SKID PLATE

Advertisement

loading

  Related Manuals for Husqvarna 16530-LS