Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Perreaux 200i
Summary of Contents for Perreaux 200i
- Page 1 MODEL 200i/200iP DUAL CHANNEL INTEGRATED AMPLIFIER OWNERS MANUAL...
-
Page 2: Table Of Contents
All warnings on the 200iP and in the Owners operation facet clearly and concisely. Your Manual should be strictly adhered to. Perreaux dealer will be happy to assist if you encounter any unforeseen problems. 4. Water and Moisture The 200iP should not be used near water, for... -
Page 3: Important Information
sink, laundry tub, in a wet basement, near a DO NOT USE SOLVENTS. correct, and are maintained through-out the swimming pool, etc. entire system. 10. Non-use Periods 5. Rack / Wall / Ceiling Mounting The mains power cord of the 200iP should WARNING: THE 200iP IS AN EXTREMELY The 200iP should be rack mounted only in a be unplugged from the mains/line outlet... -
Page 4: Rear Panel Description Of Functions
5 CD INPUT AND EFFECTIVELY CONVERTS THE 200iP positions and supplies the chosen source to The 200i has 2 pairs of CD inputs, the first INTO A 200 WATT POWER AMPLIFIER DO the Main Preamp outputs and VCR/ Tape pair being “Neutrik” type balanced inputs and... - Page 5 12 TAPE OUTPUT Connecting your tape deck input to this output Note: When the rear switch is in the down or will provide a suitable level for recording. couple position, the preamp and power amplifier sections of the 200iP are connected 13 PREAMP OUT Note: The 200ip resets the volume to minimum internally and effectively the pre out and main...
-
Page 6: Remote Control
VCR SOURCE SELECT revert to its normal operation. your safety and a lifetime of trouble free Pressing this control selects the ‘VCR’ source operation from your PERREAUX 200iP. (input). BALANCE LEFT (Labelled 10) LD SOURCE SELECT BALANCE RIGHT (Labelled 10+) REMOTE CONTROL Pressing this control selects the ‘LD source’... -
Page 7: Tape Dubbing
The Remote control uses 2 internal "AAA" white, black or blue for the left channel. batteries and may be changed by sliding forward Terminate speaker cables using red for positive Connect your CD player to the CD inputs ( 5) the plastic cover located on the bottom of the (+) and black, white or blue for negative (-). -
Page 8: Installation And Operation Precautions
200iP. Supply voltage must - Always turn your Perreaux 200iP on last and If you require the voltage setting to be altered, be within +/- 5% of the stated voltage -see off first making sure the volume control is set e.g. -
Page 9: Mains/Line Fuse
8Ω from 20Hz to 20kHz at no more than from the Mains/Line supply before any covers 0.020 THD) are removed. All Perreaux units are allocated a unique serial number which is recorded at the factory against 4 Ohm Rating 300 Watts RMS build details. - Page 10 PERREAUX Model 200iP Designed and Manufactured in New Zealand By PERREAUX INDUSTRIES LTD PO Box 47- 413 Ponsonby Auckland NEW ZEALAND Tel: +64 9 815 5452 Fax: +64 9 815 5981 E-mail: info@perreaux.com Website: www.perreaux.com PERREAUX INDUSTRIES LTD RESERVES THE RIGHT TO CHANGE SPECIFICATIONS ON THIS PRODUCT AT ANY TIME.
Need help?
Do you have a question about the 200i and is the answer not in the manual?
Questions and answers