Troubleshooting - Husqvarna 1330SB-XLSB Owner's Manual

Husqvarna snow blower user manual
Table of Contents

Advertisement

See appropriate section in manual unless directed to a qualified service center.
PROBLEM
Does not start
1. Fuel shut-off valve (if so
2. Safety ignition key
3. Out of fuel.
4. Throttle in STOP position.
5. Choke in OFF position.
6. Primer not depressed.
7. Engine is flooded.
8. Spark plug wire is
9. Bad spark plug.
10. Stale fuel.
11. Water in fuel.
Loss of power
1. Spark plug wire loose.
2. Throwing too much snow.
3. Fuel tank cap is covered
4. Dirty or clogged muffler.
Engine idles or
1. Choke is in FULL position.
runs roughly
2. Blockage in fuel line.
3. Stale fuel.
4. Water in fuel.
5. Carburetor is in need of
Excessive
1. Loose parts or damaged
vibration
Recoil starter
1. Frozen recoil starter.
is hard to pull
Loss of traction
1. Drive belt is worn.
drive / slowing
2. Drive belt is off of pulley.
of drive speed
3. Friction drive wheel is worn.
Loss of snow
1. Auger belt is off of pulley.
discharge or
2. Auger belt is worn.
slowing of
3. Clogged discharge chute.
snow discharge
4. Augers / impeller jammed.

TROUBLESHOOTING

CAUSE
equipped) in OFF position.
is not inserted.
disconnected.
with ice or snow.
adjustment or overhaul.
augers or impeller.
(if so equipped)
CORRECTION
1. Turn fuel shut-off valve to OPEN position.
2. Insert safety ignition key.
3. Fill fuel tank.
4. Move throttle to FAST position.
5. Move to FULL position.
6. Prime as instructed in the Operation section of this manual.
7. Wait a few minutes before restarting, DO NOT prime.
8. Connect wire to spark plug.
9. Replace spark plug.
10. Drain fuel tank and carburetor, refill tank with fresh gasoline.
11. Drain fuel tank and carburetor, refill tank with fresh gas o line.
1. Reconnect spark plug wire.
2. Reduce speed and width of swath.
3. Remove ice and snow on and around fuel tank cap.
4. Clean or replace muffler.
1. Move choke to OFF position.
2. Clean fuel line.
3. Drain tank and refill with fresh, clean fuel.
4. Drain fuel tank and carburetor, refill tank with fresh gasoline.
5. Contact a qualified service center.
1. Tighten all fasteners. Replace damaged parts.
If vibration remains, contact a qualified service center.
1. See "IF RECOIL STARTER HAS FROZEN"
in the Operation section of this manual.
1. Check / replace drive belt.
2. Check / reinstall drive belt.
3. Contact a qualified service center.
1. Check / reinstall auger belt.
2. Check / replace auger belt.
3. Clean snow chute.
4. Remove debris or foreign object from augers / impeller.
19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

96193004100

Table of Contents