Cable Installation And Removal - Honeywell Eclipse MS5100 Installation And User Manual

Cable Installation and Removal

Installation
1. Insert the cable's modular connector into the socket on the scanner.
2. Pull gently on the cable strain relief to ensure the cable is installed.
Note: If the PowerLink cable is not fully latched, the unit can power
intermittently.
Removal
Disconnect the power supply from the PowerLink cable and turn off power to the
host system before removing the cable from the scanner.
1. Locate the small 'pin-hole' on the front
side of the scanner near the end of the
handle.
2. Bend an ordinary paperclip into the shape
shown.
3. Insert the paperclip (or other small metallic
pin) into the small 'pin-hole'. There will be
a faint 'click' when the connector's lock
releases.
4. Pull gently on the cable's strain-relief to
remove the cable.
6
Figure 3.
Figure 4.