Download Print this page

Westinghouse WDF901SA Installation Manual page 2

Built under & free standing dishwashers

Advertisement

100mm
595mm
120mm
TypiCal builT-unDer insTallaTion
There should be a minimum
The hose should not be
2mm gap between the top of
extended by more than
the dishwasher and
2 metres or water pump-out
underside of bench top
problems may occur
DISHWASHER
Gap on both sides
should be equal and no greater
than 3mm per side
If floor is not level, adjust
levelling legs to suit
levelling
Good levelling is essential for correct closure and sealing
of the door.
When the appliance is correctly levelled, the door will not
catch or rub on either side of the cabinet.
Leave a space of 2mm between the top of the dishwasher
and the underside of the kitchen counter.
Check if the
dishwasher is levelled
The height of the recess where the dishwasher is to be installed
can vary between 855mm and 860mm from the floor (with
worktop) and 825-830 (without worktop) since the dishwasher is
fitted with adjustable feet (max. 10mm). If worktop is removed a
filler piece may be required.
Leave a space of 2mm between the top of the dishwasher
and the underside of the kitchen counter.
CAUTION
180mm
50mm
555mm edge of door
585mm centre of door
Fix drain hose max of
10mm below the top of
the dishwasher
600mm max -
300mm min
POWER OUTLET
FiTTing The sTeam proTeCTion
Fit the adhesive steam protection onto the front part of the
worktop, along the entire width.
855-860mm with worktop
825-830mm without worktop
ConneCTion To waTer supply
The inlet hose should be inspected every 12 months for
deterioration and replaced if necessary.
600mm
• Cold water connection
• Water hammer
SINK
1000mm max
POWER SUPPLY
230/240V–10Amps
CAUTION
600mm
– We recommend connection to a cold water supply.
– W ater pressures between 50kPa and 800kPa are
acceptable.
– A pressure-reducing valve must be fitted if the cold water
supply exceeds 800kPa. (Refer also to the remarks in the
section below concerning water hammer.)
Q uick action household taps and fast acting water valves
on appliances can cause water hammer. This can result in
very high water pressures. High pressure can cause failure
of the pressure reducing valve (where fitted), or the water
valve in your dishwasher.
Remove entire plastic
membrane from sink trap
spigot & fit drain hose to
spigot with clamp
TAP CONNECTION
If cold-water pressure is
in excess of 800kPa, a
pressure-reducing valve
should be used.
Check for leaks.
INLET WATER SUPPLY
Water flow rate 10L/minute min
Water temperature 60
o
C max
Water pressure cold water:
800kPa max - 50kPa min
Water pressure hot water:
350kPa max - 50kPa min
Cold water recommended
2

Advertisement

loading

This manual is also suitable for:

Wdf901waWdf902saWdf902wa