Cutting Blades - Husqvarna 1152450-26 Operator's Manual

Cutting blades

WARNING! A cutting blade may burst and
!
cause injury to the operator.
Never use a cutting blade at a lower speed
rating than that of the power cutter.
Never use a cutting blade for any other
materials than that it was intended for.
General
• Cutting blades are available in two basic designs;
abrasive discs and diamond blades.
• High-quality blades are often most economical. Lower
quality blades often have inferior cutting capacity and a
shorter service life, which results in a higher cost in
relation to the quantity of material that is cut.
• Make sure that the right bushing is used for the cutting
blade to be fitted on the machine. See the instructions
under the heading Assembling the cutting blade.
Suitable cutting blades
Cutting blades K3000
Abrasive discs Yes
Diamond blades Yes
Rescue blade No
*Without water
Cutting blades for different materials
Concrete
Abrasive discs X
Diamond
X
blades
Hand-held, high-speed machines
Our cutting blades are manufactured for high-speed, portable
power cutters. If blades from other manufacturers are used,
ensure that the blades conform to all regulations and
demands that concern this type of power cutter.
Special blades
Some cutting blades are designed for stationary equipment
and for use with attachments.Such cutting blades must not be
used on portable power cutters.
Always contact local authorities and make sure you are
following applicable directives.
10 –
English
SAFETY INSTRUCTIONS
K3000 Wet
Yes*
Yes
No
Metal Plastic
X X
Blade vibration
The blade can become out-of-round and vibrate if an
excessive feed pressure is used.
A lower feed pressure can stop the vibration. Otherwise
replace the blade. The blade must be of the recommended
type for the material to be cut.
Abrasive discs
The cutting material on abrasive discs consists of grit bonded
using an organic binder. "Reinforced blades" are made up of
a fabric or fibre base that prevents total breakage at maximum
working speed if the blade should be cracked or damaged.
A cutting blade's performance is determined by the type and
size of abrasive corn, and the type and hardness of the
bonding agent.
Check that the blade is approved for the same or higher
speed according to the aproval plate of the engine. Never use
a cutting blade with a lower speed rating than that of the
power cutter.
Ensure the blade it not cracked or damaged in any other way.
Test the abrasive disc by hanging it on your finger and tapping
it lightly with a screwdriver or the like. If the disc does not
produce a resonant, ringing sound it is damaged.
Abrasive discs for different materials
Disc type Material
Concrete, asphalt, stone masonry,
Concrete disc cast iron, aluminium, copper,
brass, cables, rubber, plastic, etc.
Steel, steel alloys and other hard
Metal disc
metals.
WARNING! Avoid using abrasive discs with
!
water. The strength is impaired when
abrasive discs are exposed to moisture.