Removing The Unit; Specifications - Sony CDX-GT540UI Operating Instructions Manual

-
Removing the unit
1
Remove the protection collar.
o
Detach the front panel (page 7).
e
Pinch both edges of the protection collar,
then pull it out.
2
Remove the unit.
o
Insert both release keys simultaneously
until they click.
Hook facing
inwards.
e
Pull the release keys to unseat the unit.
Specifications
AUDIO POWER SPECIFICATIONS
CEA2006 Standard
Power Output: 17 Watts RMS x 4 at
4 Ohms
<
1% TI-ID+N
SN Ratio: 82 lIBA
(reference: I Watt into 4 Ohms)
Tuner section
FM
Thning range: 87.5 - 107.9 MHz
Antenna (aerial) terminal:
External antenna (aerial) connector
Intermediate frequency: 150 kHz
Usable sensitivity: 10 dBf
Selectivity: 75 dB at 400 kHz
Signal-to-noise ratio: 70 dB (mono)
Separation: 40 dB at I kHz
Frequency response: 20 - 15,000 Hz
AM
Thning range: 530 - 1,710 kHz
Antenna (aerial) terminal:
External antenna (aerial) connector
Intermediate frequency: 25 kHz
Sensitivity: 26
~V
CD Player section
Signal-to-noise ratio: 120 dB
Frequency response: 10 - 20,000 Hz
Wow and flutter: Below measurable limit
USB Player section
Interface: USB (Full-speed)
Maximum current: 500mA
Power amplifier section
Output: Speaker outputs (sure seal connectors)
Speaker impedance: 4 - 8 ohms
Maximum power output: 52 W x 4 (at 4 ohms)
22
e
Slide the unit out of the mounting.
General
Outputs:
Audio outputs terminal (front, sub/rear switchable)
Power antenna (aerial) relay control terminal
Power amplifier control tenninal
Inputs:
BUS control input terminal
BUS audio input terminal
Remote controller input terminal
Antenna (aerial) input terminal
AUX input jack (stereo mini jack)
USB signal input connector
Tone controls:
Low:
±IO
dB at 60 Hz (XPLOD)
Mid: ±IO dB at 1 kHz (XPLOD)
High: ±IO dB at 10 kHz (XPLOD)
Power requirements: 12 V DC car battery
(negative ground (earth))
Dimensions: Approx. 178 x 50 x 179 mm
(7 '/8 x 2 x 7 '/8 in) (w/h/d)
Mounting dimensions: Approx. 182 x 53 x 162 mm
(7 '/4 x 2 '/8 x 6 '/2 in) (w/h/d)