Blade Maintenance; Maintenance And Service; Maintenance And Cleaning - Bosch Isio Original Instructions Manual

14 | English
Cutting Hedges (shrub shear only)
Before cutting check the hedge for foreign ob-
jects e. g. wire fences.
Cut stems up to 8 mm in thickness. When cut-
ting, move steadily along the line of cut, so that
stems are fed directly into the cutter blades.
The double edge of the cutting blade enables
cutting to either direction, or with a side to side
motion.
After use replace the blade transport guard.
Recommended times
– Cut hedges with deciduous leaves in June
and October.
– Cut evergreen hedges in April and August.
– Cut conifer and other fast growing shrubs ap-
prox. every six weeks from May onwards.
Edging (grass shear only) (see figure D)
Guide the garden product along the edge of the
lawn. Do not allow the blade to contact paved
surfaces, stones or garden walls, since this will
wear the blade rapidly.
For larger lawn it is advisable to use the pole
cart (available as an accessory or supplier with
"grass shear & pole cart" set).
After use replace the blade transport guard.

Maintenance and Service

Maintenance and Cleaning

Warning! Switch off before adjusting or
cleaning. The blades continue to move for a
few seconds after the garden product is
switched off.
Caution! Do not touch the moving blades.
For safe and proper working, always keep
the garden product clean.
Always wear protective gloves when using,
adjusting or cleaning the garden product.
Note: To ensure long and reliable service, carry
out the following maintenance regularly.
F 016 L70 632 | (23.7.10)
Regularly check for obvious defects such as
loose fixings, and worn or damaged compo-
nents.
Check if guards and protective devices are un-
damaged and properly mounted. Before using,
carry out possibly necessary maintenance and
repairs.
If the garden product should happen to fail de-
spite the care taken in manufacture and testing,
repair should be carried out by an authorised
customer service agent for Bosch garden prod-
ucts.
In all correspondence and spare parts orders,
please always include the 10-digit article
number given on the type plate of the garden
product.

Blade Maintenance

Always clean the cutting blades after operation
and lubricate with Bosch Maintenance spray.
During longer cutting jobs, we recommend peri-
odically lubricating the cutting blade with Bosch
Maintenance spray.
Visually check the condition of the cutting edges
of the cutting blade.
Ensure that the cutting blade is covered with the
blade guard supplied when not in use.
Changing the Blade (see figures E
Warning! Switch off before adjusting or
cleaning. The blades continue to move for a
few seconds after the garden product is
switched off.
Caution! Do not touch the moving blades.
Always wear protective gloves when using,
adjusting or cleaning the garden product.
Do not do the blade change without blade
covers.
Blade Removal (see figures E–G)
Push the SDS drive cover release button
E F
15 and slide the SDS drive cover 7 towards the
On/Off switch 5. Lift away from the housing.
Lift the blade 1 out.
G
J)
–
Bosch Power Tools