Establishing A Wired Connection - JVC GV-LS2 User Manual

Establishing a wired connection

When establishing a wired connection to the computer or access point, attach the supplied LAN cable as follows.
Required operating environment
Browser: Internet Explorer 9 or later
1 Set the network mode switch to "LAN(OFF)".
MIC
RESET
DC
DIRECT WLAN LAN(OFF)
AV
ETHERNET
DIRECT WLAN LAN(OFF)
• If the network mode switch is set to [DIRECT] or [WLAN], the LAN terminal cannot be used.
• While the power is on, switching the network mode switch does not change the setting.
2 Attach the conversion cable to the stopper of the LAN cable.
3 Attach the LAN cable to the unit in numerical order.
2
M IC
PL UG
PO WE IN
A V
R
E X T
E N D
D C
3
• Attach the cable without twisting.
• When using a tripod, make sure the cable does not come into contact with its handle.
• Do not put obstacles near the cable. Otherwise, the pantilter may not move properly.
• Do not use cables (AV cable, microphone, etc.) with L-shaped connecters.
• The center position of the camera may differ slightly under circumstances such as at low temperatures; however,
this is not malfunction.
4 Connect the camera to your computer via the LAN cable.
1
M IC M IC
P L U P L U
G IN G IN
P O W P O W
E R E R A V A V
E X T E X T
E N D E N D
D C D C
Stopper
Hold the joint gently and insert.
27