Download Print this page

Assembly - Husqvarna YTH2748 Owner's Manual

Husqvarna lawn tractor owner's manual
Hide thumbs

Advertisement

Table of Contents
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Stan dard
wrench sizes are listed.
(2) 3/4" wrenches
(2) 7/16" wrenches
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).
TO REMOVE TRACTOR FROM
CAR TON
UNPACK CARTON
Remove all accessible loose parts and parts cartons
from carton.
Cut along dotted lines on all four panels of carton.
Remove end panels and lay side panels fl at.
Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRAC TOR FROM
SKID
ATTACH STEERING WHEEL (See Fig. 1)
Remove locknut and large fl at wash er from steering
shaft.
Position front wheels of the tractor so they are pointing
straight forward.
Position steering wheel so cross bars are horizontal
(left to right) and slide onto steering wheel adapter.
Secure steering wheel to steering shaft with locknut
and large fl at wash er pre vi ous ly removed. Tight en
securely.
Snap steering wheel insert into cen ter of steering
wheel.
Remove protective materials from tractor hood and
grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN
SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO
ROLL OFF SKID.

ASSEMBLY

Pliers
Tire pressure gauge
Utility knife
STEERING WHEEL
STEERING
SHAFT
INSTALL SEAT (See Fig. 2)
Adjust seat before tightening adjustment knob.
Remove adjustment knob and fl at washer securing
seat to cardboard packing and set aside for assembly
of seat to tractor.
Pivot seat upward and remove from the cardboard pack-
ing. Remove the cardboard packing and discard.
Place seat on seat pan so head of shoulder bolt is
positioned over large slotted hole in pan.
Push down on seat to engage shoulder bolt in slot and
pull seat towards rear of tractor.
Pivot seat and pan forward and assemble adjustment
knob and fl at washer loosely. Do not tighten.
Lower seat into operating position and sit on seat.
Slide seat until a comfortable position is reached
which allows you to press clutch/brake pedal all the
way down.
Get off seat without moving its ad just ed position.
Raise seat and tighten adjustment knob securely.
6
STEERING WHEEL INSERT
LOCK NUT
LARGE FLAT WASHER
STEERING
WHEEL ADAPTOR
FIG. 1

Hide quick links:

Advertisement

Table of Contents
loading

  Related Manuals for Husqvarna YTH2748

This manual is also suitable for:

Yth1848xp