Awd Front Prop Shaft Removal - Polaris SPORTSMAN 400 2003 Service Manual

Atv
Hide thumbs Also See for SPORTSMAN 400 2003:
Table of Contents

Advertisement

FINAL DRIVE
Hub Seal Sleeve Replacement
3.
New front drive axle CV joint assemblies and
drive axle assemblies have the seal sleeve
installed from the factory.
Not Unusual To See
Two Wear Rings
Inner Magnet Pole
(Fixed)
Coil
Seal Sleeve
(Outer Magnet
Pole) (Adjustable)
Pole Gap:
.000"- -.001" (.00- -.025 mm)
Seal Sleeve Installation Tool Kit:
(PN 2871199)
4. The hub seal sleeve must be driven onto the strut
casting until flush with the inner magnet pole. Use
the flat side (no step) of the Seal Sleeve
Installation Tool Kit (PN 2871199).
5. To check the gap between the inner and outer
poles place a straight edge on the outer pole so
that it just intersects with the inner pole. The gap
between the straight edge and inner pole should
be 0 to .001I (0-.025mm). This measurement
should be checked in three different positions
around the pole assemblies.
measurements must be within .0005I (.013 mm)
of each other. If the gap is excessive, the hub may
notengage.
Seal Sleeve Tool
Use flat side to install seal sleeve
Step
7.14
Max. .001²
(.025mm)
Measure at 3
places 120_
AWD FRONT PROP SHAFT
apart
REMOVAL
1. Using Roller Pin Removal Tool (PN 2872608),
The three
NOTE: If removing front housing, use roll pin remover
to remove the roll pins from both front drive axles.
Inner Pole Shoe
remove the roll pin from the prop shaft at rear of
housing. Slide prop shaft back and away from
front housing. Pull sharply forward to remove
from transmission shaft.
Roller Pin Remover Tool (PN 2872608)
Seal
Sleeve
(Outer
Magnet
Pole)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sportsman 500 2003

Table of Contents