Fujitsu ScanSnap N1800 Operator's Manual page 451

In Internet Explorer, in the [Tools] menu, [Internet Options], [Security]
tab, the security level for the corresponding zone is set as [High].
Or in [Custom level], [Scripting], [Active scripting] is set to [Prompt] or
[Disable].
■ Action
When connecting using the scanner name, the connection will be an intranet connection. When
connecting using an IP address, it will be an internet connection. If the URL includes a scanner
name, the scanner will be connected using an Intranet Zone. If the URL includes an IP address,
the scanner will be connected using the Internet Zone.
Try the following settings for the corresponding zone.
1. In Internet Explorer, set the following settings in the [Tools] menu, [Internet Options].
2. Enable active scripting in either of the following ways.
On the [Security] tab, select the [Default Level] button. Then, set the required [Security level
for this zone] to [Medium].
On the [Security] tab, select the [Custom level] button. Then, set [Scripting], [Active
scripting] to [Enable].
3. If connecting via the Internet zone, on the [Privacy] tab, set the level to below [Medium High].
4. Delete temporary internet files in either of the following ways:
On the [General] tab, press the [Delete Files] button on the [Temporary Internet Files].
On the [General] tab, press the [Delete] button on the [Browsing history], and press [Delete
Files] button on [Temporary Internet Files].
On the [General] tab, press the [Delete] button on the [Browsing history], then select the
[Temporary Internet Files] check box and press [Delete] button.
The scanner is in standby mode.
■ Action
Press the power button to start the scanner.
A proxy server is being used.
■ Action
Set the proxy server to not be used.
1. In Internet Explorer, set the following settings in the [Tools] menu, [Internet Options].
2. Press the [LAN settings] button on the [Connections] tab.
3. Clear the [Use a proxy server for your LAN (These settings will not apply to dial-up or VPN
connection).] check box.
There is an error with the connection protocol setting.
■ Action
Check if SSL is enabled on the [Admin Connection] window.
For details, refer to
There is an error with the port number setting.
■ Action
Check the specified port number on the [Admin Connection] window.
For details, refer to
"4.8.8 Setting the Admin Connection" (page
"4.8.8 Setting the Admin Connection" (page
451
120).
120).