Lenovo ThinkCentre M73 User Manual page 61

6. Follow the following sequence to remove the four screws that secure the heat sink and fan assembly
to the system board:
a. Partially remove screw
b. Partially remove screw
Note: Carefully remove the four screws from the system board to avoid any possible damage to the
system board. The four screws cannot be removed from the heat sink and fan assembly.
Figure 23. Removing the heat sink and fan assembly
7. Lift the failing heat sink and fan assembly off the system board.
Notes:
• You might have to gently twist the heat sink and fan assembly to free it from the microprocessor.
• Do not touch the thermal grease while handling the heat sink and fan assembly.
8. Position the new heat sink and fan assembly on the system board so that the four screws are aligned
with the holes on the system board.
Note: Position the new heat sink and fan assembly so that the heat sink and fan assembly cable is
toward the microprocessor fan connector on the system board.
9. Follow the following sequence to install the four screws to secure the new heat sink and fan assembly.
Do not over-tighten the screws.
a. Partially tighten screw
b. Partially tighten screw
10. Connect the heat sink and fan assembly cable to the microprocessor fan connector on the system
board. See "Locating parts on the system board" on page 12.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
1 , then fully remove screw
3 , then fully remove screw
1 , then fully tighten screw
3 , then fully tighten screw
2 , and then fully remove screw
4 , and then fully remove screw
2 , and then fully tighten screw
4 , and then fully tighten screw
.
Chapter 5 Installing or replacing hardware
1 .
3 .
1 .
3 .
49