Installation; Positioning The Tool; Functional Description; Switch Action - Makita LC1230 Instruction Manual

10. Be careful not to damage the arbor, flanges
(especially the installing surface) or bolt. Dam-
age to these parts could result in blade break-
age.
11. Make sure that the base is properly secured so it
will not move during operation. Use the holes in
the base to fasten the saw to a stable work plat-
form or bench. NEVER use tool where operator
positioning would be awkward.
12. For your safety, remove the chips, small pieces,
etc. from the table top before operation.
13. Make sure the shaft lock is released before the
switch is turned on.
14. Be sure that the blade does not contact the base
in the lowest position.
15. Hold the handle firmly. Be aware that the saw
moves up or down slightly during start-up and
stopping.
16. Make sure the blade is not contacting the work-
piece before the switch is turned on.
17. Before using the tool on an actual workpiece, let
it run for a while. Watch for vibration or wobbling
that could indicate poor installation or a poorly
balanced blade.
18. Wait until the blade attains full speed before cut-
ting.
19. Stop operation immediately if you notice any-
thing abnormal.
20. Do not attempt to lock the trigger in the on posi-
tion.
21. Shut off power and wait for saw blade to stop
before servicing or adjusting tool.
22. Be alert at all times, especially during repetitive,
monotonous operations. Do not be lulled into a
false sense of security. Blades are extremely
unforgiving.
23. Always use accessories recommended in this
manual. Use of improper accessories such as
abrasive wheels may cause an injury.
24. Do not abuse cord. Never yank cord to discon-
nect it from the receptacle. Keep away from heat,
oil, water and sharp edges.
25. Never attempt to cut workpiece less than 14
gauge (0.08") thick except pipe or workpiece
which cannot be secured firmly with a vise. The
piece cut off may be caught by the blade, caus-
ing dangerous scattering of chips and/or dam-
age to the carbide-chips. Possible serious injury
may result.
26. Unplug tool before changing blade or servicing.
SAVE THESE INSTRUCTIONS
WARNING:
MISUSE or failure to follow the safety
rules stated in this instruction manual
may cause serious personal injury.

INSTALLATION

Positioning the tool

When the tool is shipped from the factory, the handle is
locked in the lowered position. Release the handle from
the lowered position by lowering it slightly and removing
the chain from the hook on the handle.
1
Bolt the tool with two bolts to a level and stable surface
using the bolt holes provided in the tool base. This will
help prevent tipping and possible injury.
1

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.

Switch action

1
4
003771
1. Hook
003772
1. Bolt
1
003773
1. Lock-off button
2. Switch trigger
2