Husqvarna W3213 Operator's Manual page 9

TRANSMISSION DRIVE BELT
To increase the tension of the transmission belt,
loosen the nut on the underside of the transmission
idler pulley located under the rear deck, slide the idler
assembly inward to increase tension and tighten the
nut to secure. See figure 4 & 5.
BELT GUIDES
Belt guides under rear deck are adjusted as shown in
figure 4 & 5.
NOTE: The blades should come to a stop from
maximum speed within 7 seconds after disengaging.
32" & 36" MODEL
1/8" CLEARANCE
102036
103462
1/2"
ENGINE
PULLEY
103463
1/8" CLEARANCE
TRANSMISSION IDLER PULLEY
AUXILARY BELT ADJUSTMENT
ROD
IDLER PIVOT POINT
Setup & Adjustments
TRANSMISSION BELT
Figure 4
BLADE ENGAGEMENT LEVER
The blade engagement lever needs to be adjusted so
the lever does not come in contact with control panel
when the lever is in the off position.
To adjust, remove the clevis pin from the yoke and
adjust by turning the yoke. The clevis pin connects
the blade engagement lever to the yoke, and the yoke
is connected to the blade engagement rod that runs
to the bellcrank on the rear deck.
1/4" CLEARANCE
103462
102036
1/2"
ENGINE
PULLEY
103462
1/8" CLEARANCE
TRANSMISSION IDLER PULLEY
TURNBUCKLE
1/4"
ENGAGEMENT IDLER
ASSEMBLY
Figure 6
9
48" MODEL 48" MODEL
48" MODEL 48" MODEL 48" MODEL
TRANSMISSION BELT
Figure 5