Creating A Mykey; Clearing All Mykeys - Ford FUSION HYBRID 2015 Owner's Manual

CREATING A MYKEY

Use the information display to create a
MyKey:
1. Insert the key you want to program into
the ignition. If your vehicle is equipped with
a push-button start, place the intelligent
access key fob into the backup slot. The
location of your backup slot is in another
chapter. See Starting and Stopping the
Engine (page 143).
2. Switch the ignition on.
3. Access the main menu on the
information display controls, and select
Settings then MyKey by pressing OK or
the > button.
4. Press OK or the > button to select
Create MyKey.
5. When prompted, hold the OK button
until you see a message informing you to
label this key as a MyKey. The key will be
restricted at the next start.
MyKey is successfully created. Make sure
you label it so you can distinguish it from
the admin keys.
You can also program configurable
settings for the key(s). See
Programming/Changing Configurable
Settings.
To clear all MyKeys of all MyKey settings, press the left arrow button to access
the main menu and scroll to:
Message
Settings
MyKey
Clear MyKey
Fusion/Mondeo (CC7), enUSA
MyKey
Programming/Changing
Configurable Settings
Use the information display to access your
configurable MyKey settings.
1.
2. Access the main menu on the
3. Use the arrow buttons to get to a
4. Press OK or > to make a selection.
Note: You can clear or change your MyKey
settings at any time during the same key
cycle as you created the MyKey. Once you
have switched the vehicle off, however, you
will need an admin key to change or clear
your MyKey settings.

CLEARING ALL MYKEYS

You can clear or change your MyKey
settings using the information display
control on the steering wheel. See
Information Displays (page 94).
Switch the ignition on using an admin key
or fob.
Action and Description
Press the OK button.
Press the OK button.
Press and hold the OK button until the following message
displays.
53
Switch the ignition on using an admin
key or fob.
information display controls, and select
Settings, then MyKey by pressing OK
or > button.
feature.