CA10 Status Indications
Indications during use
The Private Reply button has a backlight to provide visual feedback of the CA10 status when the CA10 is in use
(not charging).
The CA10 status indications are listed in
CA10 Status Indications
Table 2-1
LED Status
No light
Blinking green
Blinking red
Blinking amber
Profiles
The CA10 uses a profile to save a collection of configuration settings for the CA10. You can create or use a default
profile and load it on the CA10 as part of system deployment (see
Resetting the CA10
If the CA10 is not functioning properly, turn off the CA10 and turn it on again (see Powering on / off on page 1-8). If
the CA10 does not respond, reset the CA10 to its factory default configuration.
Reset to factory default
To restore the CA10 to its factory default configuration:
Place the CA10 onto the cradle.
1.
Simultaneously hold down the Volume Down button and Advance button until the CA10 beeps four times
2.
followed by a fast stutter tune. The CA10 automatically restarts with factory default settings.
Configure the CA10
3.
Table
2-1.
CA10 is turned off.
•
Repeated slow blink: incoming Private Reply Call
•
Repeated fast blink: Private Reply Call is active
•
Single blink every 10 seconds: standby state
•
Repeated single blink: low power, re-charge the CA10
•
Repeated sequence of blinks: no wireless connection
CA10 is powering-up.
(Configuring the CA10 units on page
Event
Configuring the CA10 units on page
3-7).
Using the CA10
2 - 5
3-7).