The cutting unit components
In the instructions below, a cutting unit with a rear
ejector is shown, but the same principles apply to
all cutting units unless otherwise stated.
The components mentioned are:
•
A Catch
•
B Inner pin
•
C Catch guard
•
D Handle
•
E Height adjustment strut
•
F Parallelism strut
•
G Lowest height adjustment stop
Attaching the cutting unit
WARNING!
Exercise caution.
Risk of crush injuries
Starting point for attaching the cutting unit:
•
Place the machine on a flat surface.
•
Lock the brake by pressing down the pedal and
locking with the push-button.
•
Equipment hydraulics in the lower position (PF 21).
•
Equipment frame in lowered position.
•
Equipment frame locked with safety catch and locks
(A) in the inset position.
•
Unit frame mounted on the cutting unit, see
"Removing the unit frame" on page 55.
MAINTENANCE
C
B
A
F
D
E
G
8009-188
A
A
8009-022
47
English-