Husqvarna ProFlex 18 Operator's Manual page 35

4. Slide in the unit so that the inner pins (B)
bottom in the attachment frame's groove.
5. Hook the rear end of the height adjustment arm
(E) in place:
Set the cutting height lever to the forward
position. Release the pressure from the arm if
necessary by lifting or pushin down on the front
of the frame.
WARNING!
Watch your fingers. Do not turn
the blades or belt.
6. Disconnect the belt adjuster spring and fit the
belt over the front pulley. The new belt will be
shorter. If necessary, fit a spanner over the
centre bolt and turn the front pulley.
7. Hook on the belt adjuster's spring again.
IMPORTANT INFORMATION
Check that the belt is fitted around the
tension roller.
Belt diagram
1. Drive belt
2. Front pulley
3. Tension roller
4. Belt adjuster spring
8. Refit the nose.
MAINTENANCE
1
E
3
2
English –
8009-018
8009-168
8009-008
4
6016-105
33