Download  Print this page

Husqvarna LTH1742 Owner's Manual page 7

Husqvarna lawn tractor owner's manual
Hide thumbs

Advertisement

Table of Contents
HOW TO SET UP YOUR TRACTOR
INSTALL SEAT (See Fig. 2)
Adjust seat before tightening adjustment bolt.
Remove adjustment bolt, lock washer and fl at washer
se cur ing seat to cardboard packing and set aside for
as sem bly of seat to tractor.
Pivot seat upward and remove from the cardboard pack-
ing. Remove the cardboard packing and discard.
Place seat on seat pan so head of shoulder bolt is
positioned over large slotted hole in pan.
Push down on seat to engage shoulder bolt in slot and
pull seat towards rear of tractor.
Pivot seat and pan forward and assemble adjust-
ment bolt, lockwasher and fl at washer loosely. Do not
tighten
Lower seat into operating position and sit on seat.
Slide seat until a comfortable position is reached
which allows you to press clutch/brake pedal all the
way down.
Get off seat without moving its adjusted position.
Raise seat and tighten adjustment bolt securely.
SEAT PAN
FLAT WASHER
LOCK WASHER
ADJUSTMENT
BOLT
CHECK BATTERY (See Fig. 3)
Lift seat pan to raised position.
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in MAINTENANCE section of this
manual for charging instructions).
ASSEMBLY
SEAT
SHOUL-
DER BOLT
FIG. 2
SEAT PAN
NOTE: You may now roll or drive your tractor off the skid.
Follow the ap pro pri ate instruction below to remove the
tractor from the skid
.
TO ROLL TRACTOR OFF SKID (See Op-
er a tion section for location and function of
con trols)
Press lift lever plunger and raise attachment lift lever
to its highest po si tion.
Release parking brake by de press ing clutch/brake
ped al.
Place freewheel control in "trans mis sion dis en gaged
position" (See "TO TRANS PORT" in the Op er a tion
section of this manual).
Roll tractor forward off skid.
Remove banding holding the defl ector shield up against
tractor.
TO DRIVE TRAC TOR OFF SKID (See Op-
er a tion section for location and function of
con trols)
WARNING: Before start ing, read, un der stand and fol low
all in struc tions in the Op er a tion section of this man u al. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other peo ple and objects.
Be sure all the above assembly steps have been com-
pleted.
Check engine oil level and fi ll fuel tank with gasoline.
Place freewheel control in "trans mis sion en gaged"
po si tion (see "TO TRANSPORT" in Op er a tion section
of this manual).
Sit on seat in operating position, depress clutch/brake
pedal and set the parking brake.
Place motion control lever in neutral (N) position.
Press lift lever plunger and raise attachment lift lever
to its highest position.
Start the engine. After engine has started, move throttle
control to idle position.
Release parking brake.
Slowly move the mo tion control lever for ward and slowly
drive tractor off skid.
Apply brake to stop trac tor, set park ing brake and place
motion con trol lever in neutral po si tion.
Turn ignition key to "STOP" position.
Continue with the in struc tions that follow.
7
LABEL
FIG. 3

Hide quick links:

Advertisement

Table of Contents
loading

  Also See for Husqvarna LTH1742

  Related Manuals for Husqvarna LTH1742

This manual is also suitable for:

Lth18542