Cleaning And Washing; Caster Wheels; Hardware - Husqvarna iZ4217TSKAA, iZ4817TSKAA, iZ4821TSKAA, iZ5223TKOA, iZ5225TXPKOA, iZ6125TKOA, iZ5223TVAN Operator's Manual

Cleaning and Washing

Regular cleaning and washing, especially
under the mower deck, will increase the
machine's lifespan. Make it a habit to clean
the machine directly after use (after it is
cooled), before the dirt sticks.
Do not spray water on the top of the mower
deck. Use compressed air to clean the top
side of mower deck. Regularly clean deck
and underside of deck, avoid spraying engine
and electrical components with water.
Use protective glasses when
cleaning and washing.

Caster Wheels

Check every 200 hours. Lift front of unit off of
ground so caster wheels can rotate freely.
Tighten caster bolt (34) then back off 1/2 turn.
Check that wheel rotates freely. If wheel does
not rotate freely back the caster bolt off in 1/4
turn increments until wheel rotates freely.
IMPORTANT INFORMATION
DO NOT add any type of tire liner or foam
fill material to the tires. Excessive loads
created by foam filled tires will cause
premature failures.
Only use O.E.M. specified tires.
Foam filled tires or solid tires will void the
warranty.
Removal and installation of caster wheel
1. Remove nut (35) and caster bolt (34).
2. Pull the wheel out of the fork and take
care of the sleeve (36).
3. Install in reverse order. Tighten caster
bolt according to instructions above.

Hardware

Check daily. Inspect the entire machine for
loose or missing hardware.
MAINTENANCE
Cleaning
Caster wheels
8011-644
8011-619
51
English-