Setting Oven Controls
Setting the Clock
The
pad is used to set the clock. The clock may be set
for 12 or 24 hour time of day operation. The clock has been
preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the
range has been interrupted, the time in the display will flash.
To set the clock (example below for 1:30)
1.
Press
.
2. Press 1, 3 & 0 pads to set the time of day to 1:30. Press
Start.
Changing between 12 or 24 hour time of day display
1.
Press and hold
for 7 seconds. CONTINUE holding
the pad until “12Hr dAy” or “24Hr dAy” appears in the
display and the control beeps once.
2. Press Clean to switch between the 12 and 24 hour time
of day display. The display will show either “12Hr dAy”
or “24Hr dAy”.
3. Press Start to accept the change or press Stop to reject
the change.
4. Reset the correct time as described in To set the Clock
above. Please note that if the 24 hour time of day mode
was chosen, the clock will now display time from 0:00
through 23:59 hours.
Setting Continuous Bake or 12 Hour Energy
Saving
The Timer and Clean pads control the Continuous Bake or 12
Hour Energy Saving features. The oven control has a factory
preset built-in 12 Hour Energy Saving feature that will shut
off the oven if the oven control is left on for more than 11
hours and 59 minutes. The oven can be programmed to
override this feature for Continuous Baking.
To set the control for Continuous Bake or 12 Hour
Energy Saving features
Press and hold Timer for 7 seconds. After 7 seconds
1.
“12Hr OFF” or “StAy On” will appear in the display and
the control will beep once.
2. Press Clean to switch between the 12 Hour Energy
Saving and continuous bake features. Note: “12Hr OFF”
in the display indicates the control is set for the 12
Hour Energy Saving mode and “StAy On” indicates the
control is set for the Continuous Bake feature.
3. Press Start to accept the change (Display will return to
time of day) or press Stop to reject the change.