Test Light Instructions - Petsafe In-Ground Fence Operating Manual

Test Light Instructions

1. Make sure the Receiver Collar battery is properly installed.
2. Hold the Test Light contacts to the Contact Points (
3. Walk toward the Boundary Wire with Contact Points
pointing up and holding the Receiver Collar at your pet's
neck level (H) until the Receiver Collar beeps and the
Test Light fl ashes (I).
Note: The Receiver Collar is waterproof, which can make the
beep hard to hear.
Save the Test Light for future testing.
If the Test Light does not fl ash, refer
to the Troubleshooting section, or
contact the Customer Care Center
at 1-800-732-2677.
H
www.petsafe.net
G
G).
I
Boundary
Wire
11