Installation Instructions; Trash Drawer Care; General Cleaning - KitchenAid KBTU141T Use & Care Manual

Warming Drawer Size
24" (61.0 cm)
*Dimension L is the minimum mounting surface area around the opening for mounting the optional door or drawers.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
trash drawer.
Failure to do so can result in back or other injury.
IMPORTANT: Always follow label instructions on cleaning
products.
Soap, water and a soft cloth or sponge are suggested first unless
otherwise noted.
STAINLESS STEEL
Cleaning Method:
Rub in direction of grain to avoid damage.
Food spills should be cleaned as soon as possible. Spills may
cause permanent discoloration. Use stainless steel cleaner
and polish to clean spills.
KitchenAid ® Stainless Steel Cleaner and Polish Part Number
4396920 (not included) or KitchenAid
Part Number 8212510 (not included):
See "Assistance or Service" section to order.
Liquid detergent or all-purpose cleaner:
Rinse with clean water and dry with soft, lint-free cloth.
Vinegar for hard water spots
Use a glass cleaner to remove fingerprints.
To avoid damage to stainless steel surfaces, do not use soap-
filled scouring pads, abrasive cleaners, cleaners containing
chlorine, Cooktop Polishing Creme, steel-wool pads, gritty
washcloths or some paper towels.
6
Cutout Dimensions - Built-in Warming Drawer
Dimension J
22½" (57.2 cm)
Cutout Dimensions - Built-in Utility Drawer and Built-in Trash Drawer
Dimension M
12¼" (31.1 cm)

INSTALLATION INSTRUCTIONS

TRASH DRAWER CARE

General Cleaning

® Stainless Steel Wipes
Dimension L*
1½" (3.8 cm)
1. Using two or more people, lift the trash drawer and gently
insert into the cabinet cutout. Make sure the trash drawer is
flush to the face of the cabinet.
2. Open drawer to check the levelness of the trash drawer.
Install screws (not supplied) in mounting holes and tighten.
3. Close drawer.
EXTERIOR and INTERIOR
The quality of this material resists most stains and pitting,
providing that the surface is kept clean and covered.
Cleaning Method:
Apply stainless steel polish to all areas before first use.
Apply after each cleaning to avoid damage.
Cleaning should always be followed by rinsing with clean,
warm water.
Use a metal polish or stainless steel brightener to remove
fingerprints, water spots, oxidation, and food stains. Always
follow the manufacturer's directions.
Wipe the surface completely dry with a soft cloth.
TRASH CAN
Cleaning Method:
Remove and empty the trash can.
Clean with warm soapy water and a soft cloth or sponge.
Rinse with clean warm water.
Wipe dry with a soft cloth.
Replace trash can into trash drawer.