Checking Hydraulic System; Checking Battery - Husqvarna BZ6127TD/968999262 Operator's Manual

Checking the Hydraulic System
Total System Capacity..................1.125 gal.
To check the hydraulic fluid level, locate the
hydraulic reservoir under the seat. Remove cap
and check level. Fill to 1/4" from top of tank
WARNING!
If a leak is suspected, use a piece
of cardboard or wood, NOT your
hands. to check for leaks.
Escaping hydraulic oil under pres-
sure can have sufficient force to
penetrate the skin, causing seri-
ous injury.
Ifinjured by escaping fluid, see a
doctor at once. Serious infection
or reaction can develop if proper
medical treatment is not adminis-
tered immdediately.

Checking Battery

The factory installed battery is "Low Maintenance".
Add liquid only as needed.
WARNING!
UNTRAINED/UNAUTHORIZED
persons should NEVER attempt to
service or recharge the battery in
this unit.
Battery electrolyte is an acidic
solution and should be handled
with care. If electrolyte is splashed
on any part of the body, immedi-
ately flush the exposed area with
liberal amounts of water and ob-
tain medical aid immediately.
NOTE: Keep top of battery clean and free of
corrosion by washing with a solution of baking
soda and water OR ammonia and water. Rinse
with clean water. Batteries with heavy corrosion
should be removed and cleaned with solution.
Battery cable should be disconnected before using
a "Fast Charger".
42
MAINTENANCE
Hydraulic reservoir
Battery
WARNING!
DO NOT allow flames or sparks
near a battery when connecting
for jump starting or charging.
Hydrogen gas is produced during
the charging process and can be
explosive. Provide adequate ven-
tilation to prevent possible explo-
sion.
BAM-21
BAM-21