Husqvarna BZ6127TD/968999262 Operator's Manual page 30

3. Select the cutting height by placing the pin in
one of the holes. Lock the pin on the inside
with the cotter pin.
4. Press in the stop handle, counter hold, and
carefully move the lifting lever forward from
the transport position toward the pin on
manual units.
5. On power units push the hydraulic lift switch
forward to lower the deck to the selected pin
position.
IMPORTANT INFORMATION
The mower deck's anti-scalp rollers should
be evenly adjusted. See Maintenance
section.
WARNING!
Make sure that no one is near the
machine when engaging the
mower deck.
6. Engage the mower deck by pulling out the
control knob.
7. The machine's speed and direction are
continuously variable using the two motion
control levers. The motion control levers
can be moved forward or backward about
a neutral position. Furthermore, there is a
neutral position, which is locked if the
motion control levers are moved outward
into the neutral slots.
8. When both controls are in the neutral
position (N), the machine stands still.
9. The motion control levers on each side of
the mower control the direction of
movement. The left lever controls the flow
of oil from the left hydro pump to the left
wheel motor. The right lever controls the
flow of oil from the right hydro pump to the
right wheel motor.
NOTE: To begin motion, the operator must be
in the seat and the parking brake
30
OPERATION
Cutting height selection (27.5 HP)
Hydraulic switch
Engaging the mower deck
8011-561
BAM - 2
BAM - 2