Rops; Tires - Husqvarna BZ6127TD/968999262 Operator's Manual

ROPS Assembly
(Roll Over Protection System)
ROPS Assembly Components
1 - Top Loop
1 - Left Side Post
1 - Right Side Post
1 - Hardware Bag
2 - 1/2" Latch Pins w/lanyard
2 - 1/2C x 3 1/4" Cap screws
2 - 1/2C Centerlock nuts
4 - 5/8C X 3" Cap screws
4 - 5/8C Centerlock nuts
8 - 5/8 Washer, flat
2 - Knobs
(all hardware Grade 5).
1. Remove roll bar and parts bag from the box.
2. Install roll bar side posts.
a. Locate the LEFT and RIGHT side posts.
b. Using 5/8C x 3 cap screws, two per
post, align the holes in the side post with
the frame holes.
d. Install the 5/8C centerlock nuts finger tight
to the side post bolts.
3. Install roll bar top loop.
a. Align the holes of the top loop with the left
and right side posts.
b. Slide the latch pins thru the front hole on
the left and right side to connect the top
loop to the side posts and secure with the
hairpin.
c. Using 1/2C x 3 1/4 cap scrws thru the
rear hole on the left and right side.
d. Install the 1/2C centerlock nuts finger
tight.
SETUP AND ADJUSTMENTS
4. Torque all 1/2" hardware to 80 ft./lbs. (110 N•m)
and all 5/8" hardware to 97 ft/lbs. (131.5 N•m).
5. Install and tighten knobs against the side post.
LATCH PIN
1/2C X 3 1/4
CAPSCREW
1/2C CENTERLOCK
NUT
LEFT SIDE
POST
5/8C X 3
CAPSCREWS
5/8C CENTERLOCK
NUTS

Tires

Mount rear drive wheels using the lug nuts installed
on the hubs.
Check the tire pressure in all four tires. All tires
should be 16 psi.
TOP LOOP
KNOB
RIGHT SIDE
POST
15