Toshiba 48L344 DG Online Manual page 16

9. You can select Network, Frequency, Network ID
and Search Step from this screen. For highlighting
lines you see, use Up or Down button. You can
set Search Step as 8000 kHz or 1000 kHz. If
you select 1000 kHz, the TV will perform search
process in a detailed way. Searching duration will
thus increase accordingly. When finished, press
OK button to start automatic search.
10. If you select Aerial option from the Search Type
screen, the television will search for broadcasts.
11. The Auto tuning screen will appear and the
television will start to search for available stations.
The progress bar will move along the line. You
must allow the television to complete the search.
Note: You can press MENU button to cancel.
While the search continues a message will appear,
asking whether you want to sort channels according
to the LCN(*). Select Yes and press OK to confirm.
(*) LCN is the Logical Channel Number system that
organizes available broadcasts in accordance with a
recognizable channel sequence (if available).
Initial Installation -
English - 15 -
continued
After the available stations are stored, Edit Channel
List will be displayed on the screen.
Press OK button to quit channel list and watch TV.
Note: Do not turn off the TV while initializing first time
installation.
12. If you select Satellite option from the Search Type
screen, Antenna Type menu will be displayed.
There are three types of antenna selection. You
can select Antenna type as Direct, Unicable
or DiSEqC.
Direct: If you have a single receiver and a direct
satellite dish, select this antenna type. After selecting
Direct, another menu screen will be displayed.
Select an available satellite and press OK to scan
for services.
Unicable: If you have multiple receivers and a
unicable system, select this antenna type. Press
OK to continue. Configure settings by following
instructions on the screen. Press OK to scan for
services.
DiSEqC switch: If you have multiple satellite
dishes and a DiSEqC switch, select this antenna
type. After selecting DiSEqC switch, another
menu screen will be displayed. You can set four
DiSEqC options (if available). Press GREEN
button to scan all satellites or press YELLOW
button to scan only the highlighted satellite. To
save and exit press OK button.
After the available stations are stored, Channel List
will be displayed on the screen.
channels, according to the LCN, please select Yes
and then press OK button (if available).
If you like the sort