Replacing The Fuel Filter; Checking Tire Pressures; Check & Filling Coolant System - Husqvarna 968999216 Operator's Manual

Replacing the Fuel Filter

The fuel filter is located with the priming
pump. Replace the fuel filter every 800 hours
(once per season) or more regularly if it
becomes clogged.
Replace the filter as follows:
Unscrew fuel filter from pump and replace.
Every 50 hours check for water in the fuel
filter. Empty if necessary. Refer to the engine
manual.

Checking Tire Pressures

All four tires shall have a pressure of 16 PSI.
Check and Filling Coolant System
WARNING!
ALWAYS make sure the
engine is stopped and cool
before removing radiator
pressure cap. To prevent
scalding by hot fluid, NEVER
remove the radiator cap while
engine is hot
NOTE: Failure to follow the recommended
procedure for filling the cooling system will
cause engine overheating and possible
engine failure.
ALWAYS check coolant level at the overflow
reservoir. The correct level of coolant in the
over flow tank does NOT assure the radiator
is full.
It is extremely important that when antifreeze
is used, that it be mixed with water in a
separate container before adding. NEVER
add straight antifreeze to the radiator.
Recommended mix is 50/50 lowtox
phosphate-free antifreeze with tap water.
Refer to engine operator's manual.
The radiator for this cooling system is
provided with two drain valves; one at each
end of the lower tank. When draining the
MAINTENANCE
Fuel filter and fuel pump
Tire pressures
Radiator
PRIMING PUMP
FUEL FILTER
BAM-18
8011-564
BAM-19
33