Table of Contents
Advertisement
7) GL MODE : GL signal input changeover
• VBS
: The VBS signal or BBS (black burst) signal is input as an external
synchronizing signal.
• HD/VD : The HD/VD signal is input as an external synchronizing signal.
Note: During external sync with HD and VD signals, be sure to use either RGB or Y, B-Y, R-Y output
signals. Although VBS and Y/C output signals are also produced, these cannot be used as normal
output signals.
8) SC.COARSE : Coarse adjustment of subcarrier phase
Using the L or R button, select one of the following phases; 0º, 90º, 180º and 270º.
9) SC.FINE : Fine adjustment of subcarrier phase
The allowable setting range is -128 to 127.
There is no direct relationship between a numeric value and a degree of phase. If the relevant range is
exceeded, the SC COARSE setting is updated automatically to permit continuous adjustment.
10) H.PHASE : Adjustment of horizontal synchronization phase
The allowable setting range is -128 to 127.
36
Advertisement
Table of Contents
