Fitting The Blade Guard And Saw Blade - Husqvarna 335LX Operator's Manual

Husqvarna lawn mower operator's manual
Hide thumbs Also See for 335LX:
Table of Contents

Advertisement

Fitting the blade guard and saw
blade
CAUTION! Always use the recommended guard for the
cutting attachment you are using. See chapter on
Technical data.
343F, 345FX, 345FXT
The blade guard (A) is fitted using 4 screws (L) as
shown.
L
343FR, 343FRM, 343R, 345RX
Fit the holder (R) and bracket (J) with 2 bolts (H) on
the gear housing.
Then fasten the blade guard (A) with 4 bolts (L) in the
holder (N).
H
J
K
L
Fit the drive disc (B) on the output shaft.
Turn the blade shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
Insert the locking pin (C) in the hole to lock the shaft.
ASSEMBLY
A
R
A
Place the blade (D) and support flange (F) on the
output shaft.
G
F
B
C
Fit the nut (G). The nut must be tightened to a torque
of 35-50 Nm (3.5-5 kpm). Use the socket spanner in
the tool kit. Hold the shaft of the spanner as close to
the blade guard as possible. To tighten the nut, turn
the spanner in the opposite direction to the direction
of rotation (Caution! left-hand thread).
When loosening and tightening the saw blade nut, there
is a risk of injury from the teeth of the saw blade. You
should therefore always ensure that your hand is shielded
by the blade guard when doing this. Always use a socket
spanner with a shaft that is long enough to allow this. The
arrow in the diagram shows the area where you should
operate the socket spanner when loosening or tightening
the nut.
D
English
17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

343f345fxt343fr343frm343r345fx ... Show all

Table of Contents