Connecting The Boundary Wire - Husqvarna 2003-06 Operator's Manual

F. Connecting the boundary wire
Connect the boundary wire to the charging station:
1. Lift up the cover on the charging station:
• Grip under the edge of the cover with both
hands and pull straight out towards the sides.
• Now lift the cover straight up.
2. Slide in the ends of the boundary wire in the low-
ermost holes on the charging station and catch
them in the uppermost holes.
The right hand wire end should be inserted in the
right hand hole and the left hand wire end in the
left hand hole.
IMPORTANT INFORMATION
The boundary wire must not be crossed when
connecting to the charging station. Therefore
the right hand wire end must be connected to
the right hand connector on the charging station
and vice versa.
INSTALLATION
3012-268
3012-269
3012-266
3012-303
23
English-