Lifting Lever For The Cutting Unit; Cutting Height Adjustment Lever; Seat; Fuelling - Husqvarna Rider 15V2 AWD Operator's Manual

The Combi-unit, equipped with a BioClip-plug, finely chops
the cuttings to fertiliser. Without the BioClip-plug the unit
works in the same way as a rear ejection unit.

Lifting lever for the cutting unit

The lift lever is used to set the cutting unit in transport or
mowing position.
If the lever is pulled backwards the unit is raised and the
blades automatically stop rotating (transport position).
If the lock button is pressed in and the lever is moved forwards
the unit will be lowered and the blades will automatically start
to rotate (mowing position).
The lever can also be used to temporarily regulate the cutting
height, e.g. for a small mound in the lawn.

Cutting height adjustment lever

The cutting height can be adjusted to 7 different positions with
the cutting height lever.
Combi-unit 40-90 mm (1 9/16" - 3 9/16")
14 –
English
PRESENTATION

Seat

The seat has a jointed attachment on the front edge and can
be tipped forward.
The seat can also be adjusted lengthways.
To adjust move the lever under the front edge of the seat to
the left, so that the seat can be moved forward or backwards
to the required position.

Fuelling

The engine runs on unleaded petrol with a minimum octane
rating of 87 (not mixed with oil). We recommend the use of
biodegradable alkylate petrol. (max. methanol 5%, max.
ethanol 10%, max. MTBE 15%)
Do not fill the tank completely, leave an expansion area of at
least 2.5 cm (1").
!
IMPORTANT!
Do not use the fuel tank as a support area.
WARNING! Petrol is highly inflammable.
Exercise care and refuel outdoors (see
safety instructions).