Start And Stop; Control Before Starting - Husqvarna 225AI15/AI25 Operator's Manual

Husqvarna drill operator's manual
Table of Contents

Advertisement

Control before starting

• Check the cutters. Never
use cutters that are blunt,
cracked or damaged.
• Check that the machine
is in full working order.
Check that all nuts and
bolts are tightened
correctly.
• Check that the cutting attachment always stops when the
engine is idling.
• Only use the machine for what it is intended for.
• Ensure that the handle and safety functions are in order.
Never use a machine that lacks a part or has been modified
outside of the specifications.

Start and stop

Start
!
WARNING!
The gearbox and clutch drum must be
fitted before the machine is started,
otherwise the clutch can come loose and
cause personal injury.
Always move the machine about 3 metres
from the filling position before starting.
Place the machine on a firm surface. Make
sure the cutting attachment cannot come
into contact with any object. Make sure
that no unauthorised persons are in the
working area, otherwise there is a risk of
serious personal injury.
Cold engine
IGNITION:
Set the stop switch to the
start position.
CHOKE:
Set the choke control in the
choke position (A).
The choke position is also
the automatic start throttle
position.
NOTE! If the outside
temperature is very low and
the machine has not been
used in the last hour, let the
engine warm up on start
throttle setting for one
minute.
AIR PURGE:
Press the air purge dia-
phragm repeatedly until fuel
begins to fill the diaphragm.
The diaphragm need not be
completely filled.
12
– English
START AND STOP
A
Warm engine
IGNITION:
Set the stop switch to the
start position.
CHOKE:
Set the choke control in the
choke position and then
back again to its original
position (B)
In this way only the start
throttle is applied with no
choke.
AIR PURGE:
Press the air purge dia-
phragm repeatedly until fuel
begins to fill the diaphragm.
The diaphragm need not be
completely filled.
Press the machine body
against the ground using your
left hand (NOTE! Not your
foot). Grip the starter handle,
slowly pull out the cord with
your right hand until you feel
some resistance (the starter
pawls grip), now quickly and
powerfully pull the cord.
Reset the choke control as
soon as the engine fires and
repeat until the engine starts.
When the engine starts
quickly apply full throttle and
the start throttle will auto-
matically disengage.
NOTE! Do not pull the
starter cord out completely
and do not release the starter
cord from the fully extended
position. This can damage the
machine.
Stop
The engine is stopped by
switching the ignition off
using the stop switch.
B
"

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

225ai15225ai25

Table of Contents