Download Print this page

REI ST-1000 Installation And Operatioin Manual page 4

Heavy duty compact am/fm stereo weather band radio w/front-panel auxiliary input

Advertisement

OPERATION
1) Power On/Off Button
Press the Power Button to turn ON or OFF the unit.
Note: Radio can also be powered on by pressing any front button.
2) Volume/Select Knob
Rotate the knob left or right to change the volume level.
Press the knob to select one of the following functions:
VOL---BASS---TREB---BAL
Upon choosing the function, rotate the knob to adjust the desired setting.
PLEASE NOTE: If the Volume/Select Knob has not been adjusted for 5 seconds it will
automatically revert back to volume function.
3) Auto Store / Preset Scan Button
Press and hold this button for 2 seconds to auto program available stations into the
preset memory buttons. This function will erase previous memorized stations and store
the newly searched stations. Once completed, the radio will scan for 5 seconds through
each of the preset stations of either the AM or FM band and stop.
Press this button momentarily to scan preset stations.
4) Preset Memory/Recall Buttons
Press these buttons momentarily to select the preset stations.
Press and holding a button will preset the current station to the button being pressed.
**Preset buttons are Pre-assigned Frequencies in Weather Band Mode.
5) Band Selector Button
Press this button to change radio bands as follows:
FM1—FM2—FM3—AM1—AM2 —WB1
6) Tune /Seek Buttons
Under Radio mode, press the desired button momentarily to manually tune a station
moving upward or downward. Press and hold a button and the radio will automatically
seek the next available radio station. These buttons also function as Weather Band
Channel 7 (162.550 MHz) access. Under weather band mode, pressing these buttons
will select weather band channels 1-7.
7) Clock Button
Press this button to change between Clock and Mode Information display.
Setting the Time:
Press this button momentarily to display the time. Next, press and hold this button
until the hour display begins to flash. Rotate Volume/Select Knob to adjust the hour.
Press the CLK button again, and the minute display will flash. Rotate Volume/Select
Knob to adjust the minute. Press the button CLK again to save the time on the LCD.
4
8) Mode Button
Press this button to navigate between modes AUX —TUNER.
9) Scan Button
Press this button to automatically preview radios station for 5 seconds.
10) Auxiliary Input Jack
The unit is equipped with a front panel 3.5mm auxiliary input so you can connect your
external portable audio player or portable satellite radio receiver.
*It may be necessary to adjust the volume level of your portable devise to achieve an
optimal volume level.
Weather Band Mode
NOAA National Weather Radio Broadcasts from over 380 Locations throughout
the U.S. on seven VHF/FM frequencies. Tune to receive continuous weather
information 24 hours a day on one of the following frequencies.
Press preset 1 to select weather band channel 1 - 162.400MHZ
Press preset 2 to select weather band channel 2 - 162.425MHZ
Press preset 3 to select weather band channel 3 - 162.450MHZ
Press preset 4 to select weather band channel 4 - 162.475MHZ
Press preset 5 to select weather band channel 5 - 162.500MHZ
Press preset 6 to select weather band channel 6 - 162.525MHZ
**Press SEEK UP/DOWN to select weather band channel 7 - 162.550 MHz
NOTE:
For easy viewing at night, the backlighting will always be on when ACC +12V
switched power is applied. Backlighting will only shut off when the switched
ACC +12V power is removed.
TROUBLE SHOOTING
Problem
No power to Memory wire; no
Power light does not turn on
power to ACC wire; blown fuse.
Speakers not connected; speakers
No sound
connected with bad splices;
Speakers shorted to ground; total
speakers load not within 4-8 Ω/ch.
The antenna cable is not connected.
Cannot tune radio stations
The signal is too weak. The radio
is in the wrong frequency steps.
Cause
Solution
Check for both ACC &
BATTERY voltage with
Multi-meter, check all fuses.
Connect speakers to harness;
check all spliced wires; verify
speakers not shorted to chassis;
verify total speaker impedance.
Check volume level.
Connect the antenna cable.
Check the frequency spacing in
the radio's menu.
5

Advertisement

loading