Using Signal Call; Placing A Messenger Call; Defining A Representative For The Secretary - Siemens OpenStage 40 T User Manual

Making calls in an executive-secretary team
Step by Step
116

Using signal call

If a "Buzz" programmed sensor key is configured on
your executive phone, you can press a key to send a sig-
nal call to a specific destination phone (e.g. to a secre-
tary phone). On the destination phone, the phone num-
ber of the transmitting phone is also briefly displayed for
the signal call.
You can press the programmed sensor key in idle mode
and while on a call (once or several times).
If a "Buzz" programmed sensor key is not configured,
you can lift the handset and enter the "Signal call" code
to send a signal call to the destination phone.

Placing a messenger call

You can place a messenger call by pressing a key, if this
key is configured on the executive phone. Programming
a sensor key with a function
Defining a representative for the
secretary
Calls for the executive that arrive at the secretary phone
can be forwarded to another phone. To do this, you
must configure a "Alt. Answer" programmed sensor key.
The procedure for doing this is identical to the proce-
dure described in chapter "Configuring function keys"
(in this case: Representative).
Activating the representative:
S
Press the "Alt. Answer" programmed sensor key. The
LED lights up.
Deactivating the representative:
R
Press the "Alt. Answer" programmed sensor key. The
LED goes out.
page 77.