Table of Contents
Advertisement
Troubleshooting
Problem
You cannot remember your
mailbox password. You cannot
retrieve the messages from
your mailbox.
General
Problem
The handset and/or base unit
does not work.
88
Cause & Remedy
• Confirm the mailbox password using the
handset (p. 62).
• If you cannot use the handset, you can
retrieve the messages from your mailbox after
erasing the password, using the base unit;
Press [PROGRAM], [MUTE], [#], and
[9][0][0][0].
Please note that the following settings will
return to the factory preset with the Mailbox 2
and 3 passwords.
Function
Date & time
Dialing mode
Flash time
Line mode
Answering System
Number of rings
Recording time
Remote code
Recording mode
Base unit ringer volume
Base unit ringer tone
Base unit incoming call tone 2
Base unit room monitor mode Off
Base unit Talking Caller ID
Caller IQ feature
Cause & Remedy
• Check the settings (p. 12–14).
• Check whether the dialing mode setting is
correct (p. 18).
• Fully charge the battery (p. 13).
• Clean the charge contacts and charge again
(p. 14).
• Check battery installation (p. 13).
• Unplug the base unit's AC adaptor to reset it.
Plug in, and try again.
• The handset has not been registered to the
base unit. Register the handset (p. 81, steps
5 and 6).
• Re-install the battery (p. 13) and fully charge it.
Factory preset
—
Tone
700ms
B mode
On
4
3 min
11
Standard (16 min)
High
Tone 1
On
Off
Advertisement
Chapters
Table of Contents
