Step 7: Attach External Show Selection Devices As Required; Connect A Controller Keypad; Connect An Auxbox - Philips iPlayer 3 User Manual

Step 7: Attach external show selection devices as required

Input from
AuxBox

Connect a Controller Keypad

Unplug the power cord from iPlayer 3
1.
Connect the cable end with the 4-pin leads into the back of the Controller Keypad.
2.
Connect the cable end with the DB9 cable connector to serial port 1 or 2 on iPlayer 3.
3.
As needed, set the Range switch position on the back of the keypad. By default, switch
4.
position 0 (zero) sets the keypad to trigger shows 1-8 (see About Show Ranges on page 24 for
an overview of trigger ranges).
Reconnect the power cord to iPlayer 3.
5.

Connect an AuxBox

Unplug the power cord from iPlayer 3
1.
Connect the female end of the serial cable to the AuxBox serial port.
2.
Connect the male end with of the serial cable to serial port 1 or 2 on iPlayer 3.
3.
As needed, set the Range switch position on the front of the AuxBox. By default, switch
4.
position 0 (zero) sets the AuxBox to trigger shows 1-8.
Connect each external triggering device's two-wire cable to a terminal pair on the AuxBox.
5.
Connect the 24 VDC power cable to the 24 VDC terminals on the AuxBox, then plug it in.
6.
Reconnect the power cord to iPlayer 3.
7.
Input from
Controller
Keypad
.
.
Chapter 2
iPlayer 3 User Guide 12