Assembly; Fitting The Handlebar; Dismantling And Assembling The Cutter - Husqvarna M48 Pro, M53 S Pro Operator's Manual

Fitting the handlebar

Take care not to damage the cables and wires when you fold
up the handlebar.
M48 Pro
Lift up the handlebar until the handlebar's upper tubular
construction comes directly opposite to the handlebar's lower
section. Tighten the knob correctly.
M53 S Pro
Fold up the upper section of the handlebar by:
1 Fold in the engine brake handle towards the handlebar.
2 Lift up the handlebar until the handlebar's upper tubular
construction comes directly opposite to the handlebar's
lower section. Tighten the knob correctly.
Dismantling and assembling the
cutter
WARNING! Always wear heavy-duty gloves
!
when servicing and maintaining the cutting
equipment. The cutters are very sharp and
cuts can occur very easily.
The ignition lead should always be removed from the spark
plug before repair, cleaning or maintenance work.
12 –
English

ASSEMBLY

Always empty the fuel tank before you place the lawn mower
on its side.
Dismantling
• Unscrew the bolt holding the cutter.
• Remove bolt, washer and cup spring.
• Remove the cutter.
Assembly
• Position the cutter so that the cutting edge faces in the
direction of rotation.
• Fit the cup spring, make sure it centres correctly on the
engine shaft.
• Fit the washer and tighten the bolt correctly. The bolt
should be tightened with a torque of 45-60 Nm.