Kenmore 790.7744 Series Use & Care Manual page 17

Setting Warmer Drawer Controls
Warmer Drawer Recommended
Food Settings Table
Food Item
Bacon
Hamburger Patties
Poultry
Pork Chops
Fried Foods
Pizza
Gravies
Casseroles
Eggs
Roasts (Beef, Pork, Lamb)
Vegetables
Biscuits
Rolls, hard
Pastries
Rolls (soft)
Empty Dinner Plates
Warmer (Warm & Ready™) Drawer Indicator Light (some models)
The indicator light is located above the Warmer Drawer thermostat control. It turns on when the control is set, and stays on
until the control is turned OFF. The warmer drawer is inoperable during the Self-Clean cycle. The indicator light will not
come on during the Self-Clean cycle.
To Remove and Replace Warmer (Warm & Ready™) Drawer (some models)
Fig. 1
Fig. 2
To Set the Warmer (Warm & Ready™) Drawer Thermostat
Control (some models)
The thermostat control is used to select the temperature of the warmer drawer.
It is located on the control panel (See Fig. 3 on previous page). To set the
Setting
thermostat, push in and turn the knob to the desired setting. The temperatures
are approximate, and are designated by HI, MED and LO.
HI
HI
1. Turn the knob to select the desired temperature setting.
HI
2. For best results, preheat the drawer before adding food. An empty drawer
HI
will preheat in approximately 15 minutes.
HI
3. Turn the thermostat control to OFF after use.
HI
Warmer (Warm & Ready™) Drawer Temperature Selection
MED
(some models)
MED
MED
Refer to the table in the side column for recommended settings. If a particular
MED
food is not listed, start with the medium setting. If more crispness is desired,
MED
remove the lid or aluminum foil.
MED
Most foods can be kept at serving temperatures by using the medium setting.
MED
When a combination of foods are to be kept warm (for instance, a meat with 2
MED
vegetables and rolls), use the high setting.
LO
LO
Refrain from opening the warmer drawer while in use to eliminate loss of heat
from the drawer.
To Remove Warmer Drawer:
1.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever (See Fig.1).
5. Pull the drawer away from the range.
To Replace Warmer (Warm & Ready™) Drawer:
1. Pull the bearing glides to the front of the chassis glide (See Fig. 2).
2. Align the glide on each side of the drawer with the glide slots on the range.
3. Push the drawer into the range until levers "click" (approximately 2"). Pull
the drawer open again to seat bearing glides into position. If you do not
hear the levers "click" or the bearing glides do not feel seated
remove the drawer and repeat steps 1 thru 3. This will minimize
possible damage to the bearing glides.
NOTE: The Warmer Drawer will NOT operate while in the Self-Clean and "Oven
Lockout" modes
(cont'd)
Turn power off before removing the warmer drawer.
Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric power
before cleaning and servicing the warmer drawer.
17