Installation; Removing The Transit Fitting - Miele HM 29-175 Operating Instructions Manual

Installation

The rotary ironer may only be commis-
sioned by the Miele Service Department or
a Miele authorised Dealer.
This machine must not be installed in the
same room as dry cleaning machines using
perchlorethylene (PER) or Chlorofluorocar-
bons (CFCs). On combustion, the escaping
vapours are decomposed to form hydrochloric
acid which can result in dangerous conse-
quences.
Transportation to installation site
The machine should be transported on its
wooden base to the site where it will be instal-
led. Only then should it be taken off the
wooden base.
Lifting points for lifting gear such as straps
and hooks are located underneath the side
base frames of the machine stands near the
feet.
When setting up the machine leave at least
400 mm space each side of the machine so
that the side panels are accessible.

Removing the transit fitting.

Remove the transit fitting at the rear of the ma-
chine. This is not applicable to gas-heated rot-
ary ironers.
Levelling and securing the ironer
The machine must be level both lengthwise
and widthwise. Use a spirit level and adjust
the feet if necessary (use a SW = 19 mm
spanner).
When adjusting the feet loosen the locking
nuts on the fixing bracket, make the adjust-
ment then tighten the locking nuts back
against the casing.
The ironer should be secured to the floor
using the screws and dowels supplied with
the machine. The holes for the dowels should
be drilled through the holes in the
fixing bracket, (see installation diagram). After
tightening the floor fixing bolts tighten the nuts
which fix the bracket to the machine base.
Attaching the work table
The two support brackets for the work table
on the inside of the end stands should be
secured with the M 8 screws supplied.
The separately provided work table is laid on
top of the brackets, levelled so that the gap
between the feed out edge of the roller and
the work table is as small as possible, and
secured with the wood screws provided.
21 M.-Nr. 05372840