Adu Adjustment; Adjusting The Stack Guide Unit In Position - Toshiba 2060 Service Handbook

1.13 ADU Adjustment

1.13.1

Adjusting the stack guide unit in position

In duplex copying using the ADU, the difference in side deviation on both sides of the copy should be
within ±3 mm. If not, make adjustment as follows:
After stacking sheets of paper on the stack guide, check that the gap between the side stopper and the
edge of the sheet is 1.5 ± 1 mm. To adjust the gap, loosen the side switch bracket fixing screw. Move the
bracket according to the scale. After moving the bracket, initialize the ADU. Check the gap between the
side guide and the paper.
Side guide
2060, 2860/70 ADJUSTMENT
1.5 ± 1 mm
Side
guide
Stacked
sheets
1 - 44
ADU motor
bracket
Side switch
bracket
Dec. 1996 © TOSHIBA CORP.