Advertisement
!
WARNING
• Study, understand, and follow all printed
materials provided with and on this
device before use.
• Rated capacity is per pair! Do not
exceed rated capacity.
• Use as matched pair to support one end
of a vehicle only. Use only 1 pair per
vehicle.
• Use only on hard, level surfaces.
• Center load on saddle.
• Jack stands are not to be used to
simultaneously support both ends or one
side of a vehicle.
• No alteration shall be made to this
device.
• Failure to heed these markings may
result in personal injury and/or property
damage.
CARTON CONTENTS
Inside the carton box, you will find:
1. Two jack stand frames.
2. Two ratchet bars.
HOW TO ASSEMBLE JACK STANDS
(refer to Fig. 1)
1. Insert the ratchet bar into frame, orient
the racthet side to the pawl side of
frame.
2. Move the ratchet bar to lowest position
by raising the locking handle and guiding
the bar downward.
3. Support the ratchet bar with suitably
sized wooden block. With hammer
and punch or other suitable tool, press
lock tab into position to prevent
overextension and loss of ratchet bar.
SAFETY INSTRUCTIONS
ASSEMBLY
!
ADVERTENCIA
• L e e r , c o m p r e n d e r , y s e g u i r l a s
instrucciónes antes de utilizar el aparato.
• El manual de instrucciónes y la
información de seguridad deben estar
comunicado en lengua del operador
antes del uso.
• No seguir estas indicaciónes puede
causar daños personales o materiales.
! SAFETY MESSAGE !
Be sure all tools and personnel are clear
before lowering load. No alterations shall
be made to this device. Only attachments
a n d / o r a d a p t e r s s u p p l i e d b y t h e
manufacturer shall be used. Lift only on
areas of the vehicle as specified by the
vehicle manufacturer.
INSPECTION
Inspect the Jack Stands before each use.
Do not use if bent, broken or cracked
components are noted.
LOCKING
HANDLE
3
RATCHET BAR
LOCK
TAB
PAWL (INSIDE,
NOT SHOWN)
BASE
FRAME
FIG. 1
Advertisement
