Brother MFC990CW Service Manual page 342

Inljet mfc/dcp
Hide thumbs Also See for MFC990CW:
Table of Contents

Advertisement

-------------------------------------------- European models ----------------------------------------------
On the machine (base unit)
(1) Check the PIN code of the base unit with Function code 80 in the maintenance mode.
(Refer to
Chapter 9, Section
On the cordless handset
(2) Press the Menu/OK key.
(3) Press the
or
(4) Press the
or
press the Menu/OK key.
Note: Only unused base unit can be chosen.
The cordless handset enters the registration mode.
On the machine (base unit)
Complete steps (5) through (9) below within two minutes from the entry of the registration
mode.
(5) Press the Menu key.
(6) Press the
or
(7) Press the
or
(8) Press the
or
On the cordless handset
The cordless handset is searching for the base unit.
(9) Enter the 4-digit PIN code obtained in step (1) above using the numerical keys and press
the Menu/OK key.
Notes • If the machine sounds three short beeps, indicating the failure of registration, it returns
to the "Register Handset" state. Perform steps (3), (4), (8), and (9) again.
• If you want to install another cordless handset, repeat steps (2) through (4), (8), and
(9).
• Up to four cordless handsets can be registered to the machine.
On the machine (base unit)
(10) Press the Stop/Exit key. The machine returns to the standby state.
TIP: Accessing the country setting of a cordless handset
To change the country setting of the cordless handset or to set up the cordless handset so that it
starts up in the country selection mode when the end user loads a battery to the cordless handset,
follow the procedures given below.
Changing the country setting of the cordless handset
(1) Press the Menu/OK, *, 0, 7, and 4 keys in this order.
The "Set country / Press OK key" appears on the handset's LCD.
(2) Press the Menu/OK key.
Country names available appear on the handset's LCD.
9.1.4.30.)
key to choose "Register HS," then press the Menu/OK key.
key to choose any one of "Base1," "Base2," "Base3," and "Base4," then
key to choose "Initial Setup," then press the OK key.
key to choose "Register Handset," then press the OK key.
key to choose "Register," then press the OK key.
7-44
Confidential

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents