Brother MFC990CW Service Manual page 269

Inljet mfc/dcp
Hide thumbs Also See for MFC990CW:
Table of Contents

Advertisement

Star wheel holder
(10) Remove two CR frame springs from the CR support chassis.
(11) Lift up the CR support chassis.
(12) While lightly pressing down the two bosses that fit in the oval holes provided in the CR
support chassis, slide the star wheel holder to the front to release the small tabs from the
square holes of the CR support chassis and remove it.
Assembling Notes:
• When mounting the star wheel holder under the CR support chassis, first set the large
tabs on the star wheel holder in the large holes provided in the CR support chassis, then
slide the star wheel holder to the rear to set the small tabs in the square holes provided in
the CR support chassis.
• When securing the CR support chassis to the engine unit with the CR frame springs, set
those springs so that their vertical loop ends come to the front. Pass the left spring under
the idle pulley.
Idle pulley
CR frame spring
CR guide rail
CR support
chassis
Vertical
loop end
Square holes
Boss
Paper ejection roller
6-85
CR frame spring
Star wheel holder
Boss
Small tabs
Large tabs
(Front)
Large holes
(6_79)
Confidential

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents