6.1.9
Antenna & Cordless PCB ASSY
(1) Place the upper cover upside down.
(2) Remove the screw from the cordless PCB.
NOTE: Take care not to bend the wire that works as an antenna on the cordless PCB.
(3) Release the cordless flat cable of the antenna & cordless PCB ASSY from the cable guide
(shown on the next page).
(4) While lifting up the ASSY, release the antenna wire from the cable guides.
NOTE: Take care not to pull the soldered point of the antenna wire or apply force to that
point. Do not bend or pull the antenna wire.
(5) Remove the screw that secures the antenna and its support together to the upper cover.
(6) Pull the antenna and its support inward and off the upper cover.
Wire
(that works as antenna)
Antenna wire
Taptite, Torx
pan B M3x10
Antenna &
cordless PCB
ASSY
Cordless flat cable
Upper cover
placed upside down
(for models with cordless handsets)
Cordless PCB
Latch
Soldered point
(Do not pull the
antenna wire.)
Taptite, cup B
M3x12
6-46
Antenna support
Antenna
Antenna support
(6_41)
Confidential